Construction Security for New Home & Subdivision Developments

Overview

Large-scale residential builders know the problem: dozens of structures going up simultaneously across a sprawling development, and the security budget covers a few cameras on the main road. That leaves every framed house, every mechanical rough-in, every appliance delivery completely unwatched. CEECAM changes the math.

By deploying Ajax wireless motion sensors and smoke and heat detectors inside individual structures — connected through a networked set of Ajax hubs and radio extenders — CEECAM extends real security coverage from the roadway into every lot under construction. Not two cameras watching a boulevard. Dozens of sensors watching every building.

Why volume builders choose CEECAM

Traditional camera-only solutions cover common areas and hope for the best. CEECAM’s approach puts intrusion and fire detection inside the structures themselves — where the copper, the HVAC equipment, the appliances, and the finishing materials actually are. Ajax MotionCam sensors photo-verify every triggered event, and smoke and heat detectors provide monitored fire detection across the entire development.

The hardware is wireless, battery-powered, and designed to move. As framing completes on one block and starts on the next, site labourers relocate sensors from structure to structure in minutes — no electrician, no rewiring, no truck roll from CEECAM. Coverage rolls forward with the build, and every sensor reports back to a single CeePlayer dashboard that the site super and PM monitor from anywhere.

• Ajax MotionCam sensors and CurtainProtect door and window detectors in each structure under construction
• FireProtect 2 smoke and heat detection in every structure
• Wireless, battery-powered devices that labourers relocate as the build progresses
• Networked Ajax hubs spanning the full development footprint
• CSS perimeter cameras on roadways and common areas for complete layered coverage
• One CeePlayer dashboard — every lot, every sensor, every alert, one login

CEECAM vs. the typical builder setup

A conventional deployment puts two or three cameras on the main development road. They’ll capture a truck driving away with stolen materials — after it’s already gone. CEECAM puts a motion sensor inside the house where the materials are. The alert fires the moment someone enters, the MotionCam photo-verifies the intrusion, and a trained operator at CEECAM’s monitoring partners dispatches response while the intruder is still on site.

Add CSS perimeter cameras on the roadway and you have layered coverage: interior detection per structure, exterior surveillance across the development, and fire detection in every lot — all managed through one platform.